Our DHCP is coming directly from our Cisco Catalyst Switch. Switchport trunk allowed vlan (AP management IP VLAN and AP User IP VLAN) Switchport trunk native vlan (AP management IP VLAN) On my other non Meraki (Cisco Catalyst switch uplinked to switch that has DHCP) for the port that my AP is directly plugged into from wall to PP (Cisco Catalyst switch uplinked to switch that has DHCP) port Config Non Meraki (Cisco Catalyst Switch) - ip dhcp pool RESERVATION-(name of AP) They are both different VLAN IDS for each floor.ġ) Pcap on wired interface of the AP ' shows that Radius server sends a Access-Accept after which the client sends DHCP Discovers but we are not receiving any DHCP offers from the upstream. I used this link to configure https:/ / / MR/ Encryption_and_Authentication/ Configuring_RADIUS_Authentication_.Įnd goal is to implement 17 MR55 devices into my environment.1st Floor devices will use VLAN user ID xxx and 2nd Floor devices will use VLAN user ID xxx. Tunnel-Private-Group-Id:(VLAN ID of IP clients will receive when connected to AP) IP address.Ĭompleted testing to "IP address of Radius server" for corporate\username"Īll access points successfully contacted the RADIUS server. However, when I connect to the wireless SSID - I am connected but it say no internet and I get. When I test radius server from the radius servers part of the dashboard, my test is successful. USER VLAN ID for this which set up in attribute is xxx - the user who connects to this AP should get an IP that is not management IP of AP but VLAN ID xxx IP. My AP management IP for MR55-1-Downstairs-AP is configured. I have set up Configuring RADIUS Authentication with WPA2-Enterprise.
0 kommentar(er)
